Recommended Cushioned Equalizer and Wet Bolt Kit For a 2017 Winnebago Minnie 2500FL Travel Trailer

Question

Question:

I am trying to determine which cushioned equalizers will work with my trailer. Its a 2017 Winnebago Minnie 2500FL. The current equalizers bolt holes are 5 3/4inch wide on center. Height is 2inch or 1 7/8inch on center. Wheelbase appears to be 30inch distance between hubcap centers. Trailer is about 7500lbs fully loaded. Any advice would be appreciated. Thanks!

asked by: Mike R

0

Expert Reply:

I recommend using the MORryde Rubber Equalizers # MR87ZR on your 2017 Winnebago Minnie 2500FL travel trailer. You will need to combine this with either the 2-1/4" # MR46ZR or 3-1/8" # MR76ZR wet bolt kits. You will be able to confirm which kit is correct for your Winnebago by measuring the length of your current shackles from center of bolt hole to center of bolt hole. Do understand your current shackles could be slightly longer due to the holes elongating over time from the weight of the trailer.

expert reply by: Bud M

0

Answer 1

The Dexter suspension kits are high quality and include "wet bolts", bronze bushings instead of nylon and thick shackles. Properly maintained these would likely outlast typical factory kits three times over! To determine which kit is right…

view full answer...

Answer 2

Both work really well and will give you a noticeable improvement in ride quality. I scoured forums looking for someone who has tried on the same trailer and was not able to find anyone had done so. All of the feedback on both systems was that it made…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 6

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 7

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 8

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 9

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 10

Your trailer looks awesome! The Road armor equalizers #LC696740 and Equa-Flex Cushioned Equalizers #LC279687 are both pretty similar in performance even though the Road Armor has two dampers. The main difference is the size of the equalizers. The…

view full answer...

Answer 11

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Recommended Cushioned Equalizer and Wet Bolt Kit For a 2017 Winnebago Minnie 2500FL Travel Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching