No Power for Curt Echo Brake Controller on 2011 GMC Yukon
Question:
I have a curt 51180 that wont work with my 2011 gmc yukon, There is no power at the 7 pin connector. What do you suggest.
asked by: Bill B
0
Expert Reply:
I think I know what your issue is as it's rather common. The battery charge line wire under the hood is not attached to the power stud. I could explain this for you step by step here but it would be much easier for you to check out the attached help article below as it goes over all of this and more. This should then give you power so you can use the Curt Echo Wireless Brake Controller part # C51180.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
- Trailer Brake Controller
- Proportional Controller
- Hidden
- Up to 2 Axles
- Smartphone Display
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Curt Echo Full Review
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?
- Q&A: Solution for Suspension Sag on 2016 Toyota Highlander Towing Trailer