Where Does Blue Wire Go On 2011 Toyota Sienna with 7-Way RV Upgrade Kit ETBC7L
Question:
looking to upgrade my 2011 toyota sienna from the existing CURT 4-pin c59236 to your ETBC7L 7 Way Plug. I also want to use the CURT C51180 bluetooth brake controller. My question is when installing the 7-Way Upgrade Kit on the van, what do I connect the blue brake controller output wire too? I am assuming that if my brake controller is going to be bluetooth, and I do not have an existing brake controller, that I simply do not connect this wire? I would still run the fused 12V source and Reverse Signal.
asked by: Kevin K
Expert Reply:
Correct, the blue brake output wire does not need connected when installing the 7-Way RV Upgrade Kit for Trailer Brake Controller Installation part # ETBC7L. The brake output signal comes directly from the Curt Echo Wireless Brake Controller part # C51180 and goes to the trailer brakes. It can simply be taped up and tied off.
Products Referenced in This Question
7-Way RV Upgrade Kit for Trailer Brake Controller Installation - 12 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
- Trailer Brake Controller
- Proportional Controller
- Hidden
- Up to 2 Axles
- Smartphone Display
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Trailer Wiring Diagrams
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Article: Curt Echo Full Review
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How To Setup a 2019 Jeep Cherokee Trailhawk for Flat-Towing
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?