Installation of Jif Marine Dock Edging on Stainless Steel
Question:
Want to use bumper to dress concrete walk edge and protect the occasional pontoon boat visitor. I can use ss screws with washer to attach the top edge of the bumper on 12” or less centers. The side is steel and question is do you think an adhesive run full length of the side woul be adequate for light duty application?
asked by: Ken
0
Expert Reply:
I reached out to Jif Marine and if you use a marine grade adhesive on the # JIF56VR it will likely hold up when paired with the screws on the top. However, this has not been tested so there are no guarantees.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Jif Marine Dock Edging - P-Shape - 10' Long x 3-5/8" Tall x 2-3/8" Thick
- Boat Dock Bumpers
- Dock Edging
- P Shape Profile
- Vinyl
- 0 - 5 Inch Wide
- 6 - 10 Feet Long
- Black
- Jif Marine
more information >
Continue Researching
- Q&A: Dock Bumper Compatibility w/ a Corner Bumper
- Q&A: Dimensions of the Torklift Rubber Camper Bumpers # TLA7001
- Q&A: How to Select Hubs That Are Compatible with Trailer Spindle
- Q&A: Width Of Top Mounting Surface On Jif Marine Dock Edging # JIF56VR For Mounting Hardware
- Q&A: Can Leaf Springs with a Lower Weight Rating Be Used to Ease Ride of PWC Trailer
- Q&A: Replacement 4-Leaf Slipper Spring Measuring 25" Long
- Q&A: How to Activate Boat Trailer Surge Brake Lockout from the Factory 7-Way on a 2012 Toyota Tacoma
- Article: How to Tie Down a Kayak (Without a Roof Rack or Pool Noodles)