How Does the Malone AirFlow2 Crossbars Attach to Factory Rails?
Question:
How do these Malone cross bars attach to the rack of a 2016 Subaru Outback with factory rails and crossbars? Do I remove the existing cross bars or put them in the stowed position flush with the rails and attach the Malone to them?
asked by: Jaclyn
Helpful Expert Reply:
All you're going to need to do to attach the Malone AirFlow2 Roof Rack # MPG216 to your factory rails is clamp them around your bars (shown below).
Once you open the clamps, set them around your bars and tighten them down. You can see one of our techs demonstrate this around the 3:25 mark in the attached video as well.
Product Page this Question was Asked From
Malone AirFlow2 Roof Rack - Aero Crossbars - Raised Side Rails - Aluminum - 58" Long - Silver
- Roof Rack
- Complete Roof Systems
- Aero Bars
- 58 Inch Bar Space
- 2 Bars
- Overhang
- Silver
- Malone
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Brake Controller Installation on 2016 Mercedes-Benz Sprinter
- Q&A: Are There 58" Malone AirFlow2 Crossbars Available In Black
- Article: How to Install E-Track in 3 Easy Steps
- Article: Rooftop Cargo Carriers
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Installation of Slipper Spring with Open Eye End
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Rhino Rack Roof Rack Recommendation for 2008 Chevy HHR
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Malone Roof Rack Vs. Thule Roof Rack
- Article: Roof Rack Information
- Article: How to Install a Roof Rack