Will Jif Marine Underdeck Tritoon Ladder Fit 2011 Godfrey Tritoon Boat

Question

Question:

I have a Godfrey 2011 tritoon boat I’m wanting to order a 5 step or 4 whichever works front ladder that slides under the front u have the JIF ladders my front is curved which ladder will work for me?? Please I’m in desperate need of answers?? Thank U for your Time and HOPEFULLY ANSWERS IVE BEEN SEARCHING FOR

asked by: Talene

0

Expert Reply:

The 5 step # JIF52FR and the 4 step # JIF25FR will both fit your 2011 Godfrey Tritoon. This mounts underneath the deck so it won't matter that you have a curved front. Depending on where the supports are, and where you mount it, one of the corners might stick out slightly beyond the front of the deck. However, that won't impact the functionality of the ladder or be enough to cause an issue with clearance.

expert reply by: Robin H

0

Answer 1

Alright, I think we can help you out here with your questions regarding the Jif Marine pontoon boat ladders; first, let's start with the correct part numbers for the 4- and 5-step ladders so we're on the same page in that regard, and…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Will Jif Marine Underdeck Tritoon Ladder Fit 2011 Godfrey Tritoon Boat

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching