Replacement Wheel for Demco Kar Kaddy That Is Not Chrome

Question

Question:

Is there a wheel that is not chrome to replace Replacement Wheel for Demco Kar Kaddy SS Tow Dolly - Chrome Item # DM11574 I just need a wheel for a spare tire

asked by: Stephen T

1

Helpful Expert Reply:

We do have an option that isn't chrome like the # DM11574. The Replacement Wheel for Demco Kar Kaddy # DM09296 comes in white. This is perfect for a spare since it will save you some money compared to the chrome replacement wheel.

expert reply by: Robin H

1

Answer 1

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 2

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 3

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 4

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 7

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 8

I've checked with Lippert in the past and for their hydraulic leveling systems they recommend Dexron III or Mercon 5 automatic transmission fluid.

view full answer...

Answer 9

When replacing the electric winch on your 2007 Rockwood popup camper, you want to look at the weight rating and mounting-plate bolt pattern of your current winch along with the dimensions to ensure fitment. It looks like the Superwinch LT3000 ATV…

view full answer...

Answer 10

Blue Ox has an easy system for determining the weight capacity of your spring bars, whereas other companies may use measurements or printed capacity to assist. With Blue Ox, there is a 5 dimple system: No dimples means it is rated for up to 350 lbs…

view full answer...

Answer 11

To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of battery…

view full answer...

Answer 12

We have just what you are looking for. I called my contact at TDE and asked about the hub you have on your boat trailer. They told me that it was a 5-stud idler hub for a 3,500-lb axle. That means you need the part #AKIHUB-545-35-K. This is a fit for…

view full answer...

Replacement Wheel for Demco Kar Kaddy That Is Not Chrome

Products Referenced in This Question

Featured Help Information

Miscellaneous Media

Continue Researching