What Size Fuse Would Protect Peterson Interior Light part # 433600
Question:
I want to run an inline fuse for this dome light. What amp size fuse should I use?
asked by: Ray
0
Expert Reply:
The Peterson Interior Light part # 433600 that you referenced draws 28 watts or 2.33 amps so if you were to install an inline fuse you'd want it to be right at 3 amps.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Peterson Trailer Interior Dome Light w/ Switch - Incandescent - Steel Base - Clear Lens
- Trailer Lights
- Interior Lights
- Utility Lights
- Rectangle
- Surface Mount
- Incandescent Light
- 4-9/16L x 2-1/2W Inch
- White
- Peterson
more information >
Continue Researching
- Q&A: Replacement Hub and Drum Assembly for Lippert 4.4K 136214 Hub and Drum
- Q&A: Where do the Wires of a Trailer Break Away System Install Onto
- Q&A: Troubleshooting Trailer Break Away System
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Q&A: Replacement 15' Awning For Lippert Edge That Allows For Solera Screen/Family Room
- Q&A: Is There A Replacement for a Bargman Door Latch 10-30-051
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Article: Trailer Wiring Diagrams
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)