Number of Brackets That Come With Solera 12V Electric RV Awning Conversion Kit

Question

Question:

does 434724 come with 2 or 4 mounting brackets. the picture shows 2 mounting brackets. Thank you

asked by: Cathy S

0

Expert Reply:

There are two brackets - one for each of the arms - that come with the Solera 12V Electric RV Awning Conversion Kit - 69" Arms - White # LC434724.

expert reply by: Kyle S

0

Answer 1

Winding the roller to get the proper spring tension comes down to installing everything on the roller and arm side except for attaching the fabric to the awning rail that holds it. This is where you wind the roller 14 times away from the RV body and…

view full answer...

Answer 2

The awning roller that is installed on the Solera 12V Power RV Awning Conversion Kit #LC434724 that you referenced could be wound too tight and the motor can't overcome the tension. Or it's possible the battery of your RV is weak. Typically…

view full answer...

Answer 3

To get power to the controller of your Solera Smart Arm 12V Power RV Awning part #LC759404, you need to tap into an existing circuit, or run a power wire from the battery with an inline fuse holder, and a 15 amp fuse, like part #SWC9538, and part…

view full answer...

Answer 4

I may have a solution for you to convert a manual awning to a powered awning, but I checked with Lippert on this and there is not a 63" version of the Solera 18v Power RV Awning Conversion Kit like the #LC434730. However, if you're looking…

view full answer...

Answer 5

The 18.5x8.5-8 is actually an old tire size that is not used much anymore. The closest metric size to your existing tire would be 215/60-8. Your wheel most likely has a 5-on 4-1/4 inch bolt pattern (see link), you will want to make sure that the bolt…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 11

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 12

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Number of Brackets That Come With Solera 12V Electric RV Awning Conversion Kit

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching