Transferring B&W Gooseneck Hitch to 2006 Chevy Silverado 2500
Question:
Hi I have a flip over goose neck hitch that I am taking out of my 2000 half ton truck and putting it in a 2006 2500hd truck both short bed and whole I have it out I was clean it up and lube it up but I was wondering if there would be anything wrong if I would drill and tap so I could put a grease fitting in where it usually siezes up
asked by: Joe S
Expert Reply:
The correct B&W Turnoverball Underbed Gooseneck Trailer Hitch for a 2006 Chevrolet Silverado 2500 is part # BWGNRK1067 which is composed of the Center Section for B&W Turnoverball Underbed Gooseneck Hitch part # BWGNRC959 and B&W Turnoverball Gooseneck Custom Installation Kit for Chevy/GMC part # BWGNRM1067. Therefore, if you are reusing a hitch from another truck you'll need to make sure these are the parts you have.
In regards to the hitch ball getting stuck, so long as you clean the socket and ball then apply a light coat of grease you should not have any issues. I can't recommend drilling and tapping for a grease fitting though.
Products Referenced in This Question
Center Section for B&W Turnoverball Underbed Gooseneck Hitch - 30,000 lbs
- Accessories and Parts
- Gooseneck Hitch
- Hitch Only
- 30000 lbs GTW
- Turnover Ball Gooseneck
- B and W
more information >
B&W Turnoverball Gooseneck Custom Installation Kit for Chevy/GMC
- Gooseneck Installation Kit
- Installation Kit
- Turnoverball Gooseneck
- Below the Bed
- B and W
more information >
Product Page this Question was Asked From
B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Manual Ball Removal
- 7500 lbs TW
- 30000 lbs GTW
- Removable Ball - Stores in Hitch
- Wheel Well Release
- 2-5/16 Hitch Ball
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: trailer brake controller
- Shop: B&W Turnoverball Gooseneck Custom Installation Kit for Chevy/GMC
- Shop: B&W Custom Installation Kit w/ Base Rails for 5th Wheel Trailer Hitches
- Shop: Custom Underbed Installation Kit for B&W Companion 5th Wheel Trailer Hitches
- Article: Trailer Wiring Diagrams
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Video: Choosing the Right Trailer Wiring
- Search Results: 44649
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Choosing the Right Brake Controller
- Search Results: 68149
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Location of the 40-Amp Fuse for the 2006 Chevrolet Silverado Tow Package
- Shop: Cam-Action Lockable Door Latch w/ 36" Pipe for Enclosed Trailers - Zinc Plated Steel
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 25580
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Shop: Fifth Wheel Hitch
- Article: Trailer Tire Sizing
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Video: Review of Ultra-Fab Products Camper Jacks - Landing Gear - UF17-943010
- Shop: Gooseneck Hitch
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Search Results: dust cap
- Shop: Brake Controller
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Can Hydraulic Brakes of Demco Tow Dolly be Converted to Electric Brakes