Troubleshooting Backup Sensors That Constantly Beep On A Hopkins Backup Camera
Question:
I bought the hm50002 back up camera and Once I have the trailer attached should the camera still beep when I put vehicle in reverse. Mine does and it goes crazy beeping
asked by: Kathy G
Helpful Expert Reply:
If the backup sensor on your Hopkins Smart Hitch Backup Camera # HM50002 is beeping just by shifting to reverse then there's something blocking the sensor. You can try to adjust the angle of the sensors on each side to help clear up whatever is setting them off but other than that there really isn't much you can do with this system.
After doing some research this problem is very common and most people end up turning the volume down on the monitor to mute the sensors.
Product Page this Question was Asked From
Hopkins Smart Hitch Backup Camera and Hitch Aligner System
- Backup Camera
- Hitch Alignment Camera Systems
- Hardwired
- Dash Monitor
- 3.5 Inch Display
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Wiring Harness Recommendation for 2017 Lexus RX 350 with Towing Package
- Q&A: Does The LaSalle Bristol RV Roof Membrane Ship Folded Or Rolled Up
- Q&A: LaSalle Bristol XTRM Roof Membrane Install Kit Recommendation
- Q&A: Correct Replacement Oil Seal 225255UC for Ranger Boat Trailer
- Q&A: Replacement Grease Seal 225255UC for 2015 Wesco Trailer
- Article: How to Survive the Winter In Your RV
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: My Firestone Compressor Keeps Running Even When Air Bags Are Full
- Q&A: What Size Wire Gauge is Used in Vision X 9007 Halogen Headlight Bulbs with Relay Harness
- Article: How to Measure for Trailer Hitch Drop
- Article: Performance Chips and Modules
- Article: Trailer Wiring Diagrams