Options For Using Ultimate Trailer Jack # 322-RDJ-2K In Soft Sand To Prevent Sinking
Question:
Is there a larger jack foot that be pinned onto the bottom of this jack? Id prefer a wide attached foot similar to an RV landing pad if possible due to needing to set the jack down on soft sand or the like. Otherwise well continue to carry a 2 by 8 or a jack pad or similar...
asked by: Eric
Helpful Expert Reply:
One option is to remove the small foot plate on the Ultimate Trailer Jack # 322-RDJ-2K and install a Foot Pad # LC377962 from a Lippert Ground Control System. This foot pad has a 2-1/16" opening while the jack as a 2" inner tube so there will be just a little play between the 2. I recommend drilling a new hole in the foot pad as it has a larger 1/2" hole for the Lippert jacks. This pad is going to be 9" in diameter providing for a much better base in the sand than the included pad which is about 2"x 4".
If you are in very loose sand the Jack Pad # A10-0924 is 13-7/8" long by 11-7/8" wide providing for more surface area to resist sinking into the sand.
Products Referenced in This Question
StayPut Jack Stand Pad w/ Handle - 13-7/8" x 11-7/8" - Qty 2
- RV Jack Pads
- 2 Jack Pads
- Round Foot
- Square Foot
- Valterra
more information >
Replacement Rear Foot Pad for Lippert Components Ground Control 3.0 Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- Lippert
more information >
Product Page this Question was Asked From
Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 28 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Ultimate Jack
more information >
Continue Researching
- Shop: Replacement Rear Foot Pad for Lippert Components Ground Control 3.0 Leveling System
- Shop: RV Jack Pads
- Search Results: jack foot
- Search Results: ultimate trailer jack
- Search Results: rv jack pad
- Q&A: What is Shortest Bracket Height Trailer Jack with Caster Wheel
- Shop: Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Shop: Stromberg Carlson RV Jack Pads for RVs and Trailers - 9" Long x 6" Wide - Rubber - Qty 4
- Shop: Footplate for 2-1/4" Round Tube, A-Frame Jacks - 2,000 lbs
- Shop: Roadmaster Quick Foot Assembly Tongue Jack Extender - 6" Extension - 5,000 lbs
- Shop: Replacement Foot Pad for Stromberg Carlson Electric A-Frame Tongue Jack
- Shop: Replacement Footpad for Buyers Products 12-Volt Electric Jack
- Video: Review of Dexter Axle Trailer Brakes - Uni Servo Hydraulic Left, Right Brake Assembly - T2351300-200
- Search Results: 25580
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: 44649
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Video: Aries AdvantEdge Headache Rack Review
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Review of Lippert Components Replacement Foot Pad - LC324269
- Search Results: 68149
- Shop: Gooseneck Hitch
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Article: Trailer Tire Sizing
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Fifth Wheel Hitch