Will a Battery Tender Work To Maintain a 5 Amp Hour Battery and a RV Battery?

Question

Question:

Can I put this battery on a battery tender to keep it fully charged? Will the same battery tender I keep on my RV battery do the job? My trailer sits for extended periods. Thanks

asked by: Steve F

0

Expert Reply:

To determine if you will be able to use your battery tender on both a 5AH Breakaway Battery # 3801250 and your RV battery you will need to find the Amp Hour rating for your RV battery and see what your tender is rated for. We have the OptiMate 2 Smart Battery Charger # MA22WR which is rated for 12 volt batteries 3AH to 96AH. For larger batteries the Optimate 6 # MA64JR is rated for 12 volt batteries 3AH to 240AH.

expert reply by: Bud M

0

Answer 1

The Bright Way Push-to-Test Trailer Breakaway Kit #3802311 that you referenced comes with a 10 amp hour battery. I attached a picture of the battery outside of the box for you to check out as well. I attached a review video for this kit for you to…

view full answer...

Answer 2

The battery that comes with the Bright Way Trailer Breakaway Kit with Switch, 12V, 5-Amp-Hour Battery, and Charger #3802339 is a 12 volt sealed lead-acid battery and these batteries have a life cycle that can vary quite a bit, but typically it has…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 5

Depending on how the trailer was made, there will be a few spots you can check to identify the axle. First, if the trailer was pre-made by a specific company, you may be able to find this information in either the paperwork or on a placard somewhere…

view full answer...

Answer 6

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 7

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 8

The side plates of the B&W gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail of your 2004 Dodge 2500 8-foot bed. See the B&W video I included at the 7 min and 30 second mark. If your Firestone air bags like…

view full answer...

Answer 9

Though the design is slightly different you can use the Camco Horizontal 2-Stage Propane Regulator #CAM59323 in place of the Cavagna Model 524AS 2-stage regulator. I have linked a video review of this regulator for you.

view full answer...

Will a Battery Tender Work To Maintain a 5 Amp Hour Battery and a RV Battery?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching