What Are The Dimensions Of The Tapered End Of The ClearPlus Adapter for Slotted Windshield Wipers?

Question

Question:

What is the outer diameter of the narrow end to this part? The ID of my mount is 11.05mm and OD 14.10mm

asked by: Adrian

0

Expert Reply:

I went out to our warehouse and measured the ClearPlus Adapter for Slotted Push Button Windshield Wiper Arms # CPTLC, and measured .6" (15.24mm) across the tapered side with a height of .5" (12.7mm).

This adapter is designed to allow you to use the ClearPlus 17 series # CP75MR & 91 series # CP91241 windshield wipers.

Attached is a diagram showing where I measured for you to check out as well.

expert reply by: Bryce D

0

Width And Height Measurement Area
(click to enlarge)

Answer 1

When it comes to The ClearPlus Adapter for Slotted Push Button Windshield Wiper Arms - Qty 1 #CPTLC it only works with the ClearPlus 17 or 91 series wipers. I would recommend going with a new set of wipers that will fit on most types of wiper arms…

view full answer...

Answer 2

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 5

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 6

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 7

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 8

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

What Are The Dimensions Of The Tapered End Of The ClearPlus Adapter for Slotted Windshield Wipers?

Products Referenced in This Question

Continue Researching