Can Optronics LED Trailer License Plate Light with Bracket Connect to Non LED Product
Question:
I am looking at the Optronics LED Trailer License Plate Light with Bracket to connect to the existing license plate light. I have a 2017 Promaster 3500 converted RV. I recently installed a driver side rear door Spare tire holder. The problem is that it now blocks the vehicles existing license plate. I would use the Optronics product as the new license plate holder. Is there a problem with directly connecting the LED product to non LED product? Would issues with doing this should I be aware of ?
asked by: Ron C
Expert Reply:
It would be perfectly fine; there are no issues to be aware of connecting the Optronics LED Trailer License Plate Light with Bracket # LPL56CB.
Product Page this Question was Asked From
Optronics LED Trailer License Plate Light with Bracket - Submersible - 5 Diodes - Clear Lens
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- LED Light
- 8-5/8L x 3-1/4W Inch
- White
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Hub And Bearing Kit For An AL-KO 8460 Hub
- Article: Trailer Lighting Requirements
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Does the Hollywood Racks LED Light Bar item # HLY54RR Work w/ a 7-Way Connector?
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Recommended Hitch Plate for a 1999 International 4700
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Q&A: Difference Between Single, Dual and Free Backing Servo Brake Assemblies
- Q&A: Correct Replacement 1,200 lb Spring Bars for the Blue Ox 2-Point WDS
- Q&A: Light Kit and License Bracket Holder Recommendation for the Hollywood Racks Sport Rider SE
- Q&A: Best Replacement for Atwood 82543 Brake Actuator