Tekonsha Prodigy P2 Trailer Brake Controller Showing OL, PL and SH Error Codes
Question:
I am using a prodigy P2 proportional controler, and having 2-3 trouble codes. It started with code OL,PL. Last time I used it I got a SH code. I have checked my grounds,replaced 7 way plug, replaced all 4 wheel brake assys,checked connectors at controler in vehicle. Any ideas?
asked by: brian n
Expert Reply:
First, lets start by resetting the Prodigy P2. With the trailer disconnected from the vehicle, disconnect the brake controller by unplugging the harness from the rear of the unit, and plug it back in. The display will show NC for 15 seconds, and then show two dots.
The OL error code indicates that the Prodigy is drawing too much current. This is usually caused by a short on the brake output wire on the trailer or low resistance to ground on the brake wire. Look for any pinch points, or worn or cracked insulation that would allow the output wire to short out on the trailer frame. Check the ground leads that exit each brake assembly, make sure they are securely grounded to bare metal on the trailer frame. Make sure these grounding points are not corroded, as well.
The PL code will be displayed when the Prodigy loses voltage on the black wire while either the brake pedal or the manual lever is being applied. This may be caused by a loose connection or I have also seen a faulty circuit breaker case this as well.
The SH code can also be caused by a short on the output circuit. The most likely cause is dirt or corrosion build up in the trailer connectors on the vehicle and trailer. But, it could also indicate a problem with the rake magnets. I have included a link to an FAQ on testing magnets for you and a link to the installation instructions for the brake controller.
I'll link you to our Brake Controller Troubleshooting FAQ article.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Troubleshooting Error Codes SH and OL on a Tekonsha Prodigy Brake Controller
- Shop: Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs - Rear Axle
- Shop: Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle
- Shop: Suspension Enhancement
- Shop: Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 5 - Pre-Greased
- Search Results: hopkins brake controller harness
- Video: Review of etrailer Trailer Hubs and Drums - Pre Greased Hub with Integrated Drum - AKHD-550-35-K
- Shop: Dexter Nev-R-Adjust Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3.5K
- Video: Dexter Electric Trailer Brake Kit Installation 23-26
- Video: Dexter Nev-R-Adjust Electric Trailer Brake Kit Installation
- Shop: Deka Wire - Jacketed 7-Wire - per Foot
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - L44643 Bearings - Pre-Greased
- Shop: BT8 Spindle for 2,000-lb Trailer Axles - 1-1/4" Diameter
- Q&A: Meaning of Error Code PL with Prodigy P2 Trailer Brake Controller 90885
- Search Results: 916 wheel stud
- Q&A: Wire Diagram for Installing a Voyager Brake Controller on a 2002 Ford F-250
- Q&A: Trailer Brakes Only Work When Manual Switch on Brake Controller is Activated
- Video: SoftStartRV RV AC Unit Soft Start Install - Fifth Wheel
- Video: SoftStartRV RV AC Unit Soft Start Review
- Video: SoftStartRV RV AC Unit Soft Start Install - Travel Trailer
- Shop: Trailer Wiring
- Article: REDARC Tow-Pro Liberty vs Tow-Pro Elite
- Shop: Brake Controller
- Q&A: Chart With Error Codes Explained for the Prodigy P2 90885
- Q&A: Troubleshooting OL Code on a Prodigy P2 Brake Controller on a 2014 Toyota Tundra Limited
- Search Results: 12 trailer brakes
- Search Results: 12 brake shoes
- Article: Brake Controller Installation: Starting from Scratch
- Search Results: brake controller circuit breaker
- Search Results: circuit breaker
Jeff R.
2/25/2020
My Prodigy jumps from C to OG to 0.0. Ive made sure several times the controller is wired correctly. At a loss at this point.