Can Rhino Rack SUP and Surfboard Carrier RRRWP05 Fit OEM Crossbars 2022 Subaru Outback Wagon

Question

Question:

Will these fit the stock racks on a 2022 Subaru Outback? How small can they go down to widthwise 2”?

asked by: George V

0

Expert Reply:

The Rhino-Rack SUP and Surfboard Pads w/ Tie-Downs for Crossbars # RRRWP05 is a confirmed fit for the factory crossbars of your 2022 Subaru Outback. They can fit a 2 inch wide crossbar but an exact figure on how small of a bar they can fit is not available.

expert reply by: Jameson C

0

Answer 1

According to Yakima, the #Y07413 will indeed fit. It'll be a tight fit, but a fit. From what Yakima tells me, when they're wrapped around the crossbar, just enough of the Velcro will fit together for a secure fit, but the hook and loop…

view full answer...

Answer 2

I checked with Yakima and the Yakima GrandTour Premium Rooftop Cargo Box part #YA84FR is a confirmed fit for a 2015 Subaru Outback Wagon. In regards to hatch clearance, you won't have any issue although I will admit it will be close.

view full answer...

Answer 3

Yes, the older Rapid Crossroad Feet TH450R are compatible with the raised rails on your 2023 Subaru Outback Wagon. If you wanted to go with an upgraded system though, you would need the following parts: - 50" WingBar Evo Crossbars #TH711320 -…

view full answer...

Answer 4

That's just how Thule has it listed on their site. In all honesty you should be able to use either one for the raised rails on your 2022 Subaru Outback Wagon Wilderness: WingBar Evo Crossbars - 50" #TH711320 or 53" #TH711420 Evo Raised…

view full answer...

Answer 5

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

The Trailer Hub and Drum Assembly part #AKHD-545-35-K is the correct replacement for an AL-KO 7230. In regards to the braking assemblies, I suggest getting a new pair, the Electric Trailer Brake Kit part #AKEBRK-35-SA. This option will save you some…

view full answer...

Answer 8

The temperature light on your Everchill RV Refrigerator w/ Freezer #324-000119 is likely flashing because of a lack of full power to the fridge. The fridge requires 11 amps. It is likely trying to use more power than what is available which is why…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 11

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Can Rhino Rack SUP and Surfboard Carrier RRRWP05 Fit OEM Crossbars 2022 Subaru Outback Wagon

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching