Replacement Elbow for Air Bag Systems

Question

Question:

AIR LIFT 5000 KIT PART # 88299 I AM IN NEED OF AN ELBOW TUBE. IT TREADS INTO THE AIR BAG AND SNAPS IN TO THE AIR LINE.

asked by: Jorge A

0

Expert Reply:

To replace the elbow on your Air Lift item # AL88299 kit you will need the Replacement 1/4" Elbow for Air Lift Ride Control Air Helper Springs item # AL21837.

The replacement elbow has a 1/4 NPT threaded fitting and the other side has a snap in fitting.

expert reply by: Jerred H

0

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 2

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

The Air Lift WirelessONE Compressor System #AL25980EZ and Air Lift WirelessONE Compressor System #AL25980 are nearly identical with only some very minor differences in CFM and duty cycle ratings. The #AL25980EZ will also come with an easier mounting…

view full answer...

Answer 6

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 7

Yes, the Air Lift LoadLifter 5000 Air Helper Springs #AL57341 will fit your 2024 Chevrolet Silverado 2500 double cab with the Duramax diesel engine and factory puck system. We installed the upgraded Springs #AL88341 on a similar 2022 which I have…

view full answer...

Answer 8

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

The Firestone Ride-Rite Air Helper Springs #F2609 is the only kit that we have that will fit your 2020 GMC Sierra 1500 Denali with the adaptive ride control. These have a 5,000lb capacity to enhance your factory suspension under load. This will not…

view full answer...

Answer 11

The air bag kit I recommend going with to fit the Adaptive Ride Control on your 2022 GMC Sierra 1500 Limited is the Firestone Ride-Rite Air Helper Springs #F2609. Even though there are a limited amount of air bags that fit your vehicle, the Firestone…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Elbow for Air Bag Systems

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching