Trailer Hitch Receiver Fit For Regular 2018 VW Golf For Bike Rack

Question

Question:

Would this, or any other hitch you all carry, work on a 2018 VW Golf? I see references to GTI, R, and SportWagon models, but I wasnt sure which ones would fit a regular Golf. I will be using the hitch to attach a bike rack. Thanks!

asked by: Andrew

0

Expert Reply:

We do have a trailer hitch that fits a regular 2018 Volkswagen Golf, and what you need is the following:

- Curt Trailer Hitch Receiver # C11412

I verified directly with Curt that this hitch is a fit for your '18 Golf so you can carry your bike rack.

expert reply by: Kyle S

0

Answer 1

Yes we do! For your 2018 VW Golf GTI we have the Curt Class I Round Tube Receiver Hitch #C11412. This is actually the only hitch available that is confirmed to fit your vehicle and it will use existing holes in its frame for a no-drill installation.…

view full answer...

Answer 2

For the 2017 Volkswagen Golf GTI the Curt hitch part #C11412 would be the hitch you'd want. The hitch you mentioned does not fit the year you have.

view full answer...

Answer 3

The installation of the Draw-Tite Sportframe Trailer Hitch Receiver part #24979 on the 2019 Volkswagen Golf GTI does require trimming 1" off of the bumper beam mounting plates. I have attached a photo of the what that looks like. There is also a…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 9

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 10

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Trailer Hitch Receiver Fit For Regular 2018 VW Golf For Bike Rack

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching