Do Wheels of 2019 Mercedes Benz Sprinter Get Removed to Install RoadActive Suspension Kit
Question:
Hi: I am looking at your 2019 Mercedes-Benz Sprinter 2500 - Roadmaster Active Suspension Custom Leaf Spring Enhancement Kit. I have a Mercedes 2500 Sprinter Van, and Im just about to add the heavy stuff to the van build batteries, full electrical system, 25-gal water storage, cabinets, etc... the whole nine yards. Should I install these before filling the van with heavy equipment, or can they be installed afterwards? Also, must I remove the wheels to install these? Thank you!
asked by: David Z
Expert Reply:
When installing the RoadActive Suspension system kit part # RAS3620 on your 2019 Mercedes Sprinter 2500 you would need to remove the rear wheels after jacking the vehicle up off of the ground. You can have the heavier stuff installed as long as your jack is capable of lifting that additional weight when you go to install this.
Product Page this Question was Asked From
RoadActive Suspension Custom Leaf Spring Enhancement Kit
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Leaf Springs
- Standard Duty
- RAS
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Roadmaster Rear Anti-Sway Bar - 1-1/8" Diameter
- Shop: Vehicle Sway Bars
- Shop: SuperSprings Custom Suspension Stabilizer and Sway Control Kit
- Shop: Suspension Enhancement
- Shop: Roadmaster Rear Anti-Sway Bar - 1-1/2" Diameter
- Shop: Retro-Fit Kit for Dodge Sprinter Van without Factory Sway Bars
- Search Results: anti sway bar
- Search Results: sway bar
- Shop: RoadActive Suspension Custom Leaf Spring Enhancement Kit
- Video: Review of RAS Vehicle Suspension - Rear Axle Suspension Enhancement - RAS3620
- Shop: SumoSprings Solo Custom Helper Springs - Front Axle
- Shop: Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle
- Search Results: f2404
- Video: Review of SuperSprings Intl Vehicle Suspension - Suspension Stabilizer And Sway Control - SS62KV
- Search Results: electric leveling scissor jack
- Q&A: How Long Should it Take to Replace Electric Brakes and Bearings on a 6K Dexter Axle
- Q&A: Does HBA-CAM Adapter Module for Hydrastar Electric Over Hydraulic Brake Actuators have 2 or 4 Wires
- Search Results: 44649
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: 68149
- Q&A: Location of the 40-Amp Fuse for the 2006 Chevrolet Silverado Tow Package
- Shop: Trailer Wiring
- Article: Stability Control for Heavy Duty Vehicles
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Fuse Location for Trailer Brake Controller on a 2005 Chevy Silverado
- Search Results: 25580
- Video: Air Lift LoadLifter 5000 Ultimate Rear Air Helper Springs with Internal Jounce Bumpers Review
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Shop: Brake Controller