Recommended Kayak Rack Pads For A Kayak Trailer

Question

Question:

I am looking for rack pads for my kayak trailer. The crossbars are 2x2inch aluminum. I am looking for pads close to 25inch long. Any Suggestions?

asked by: William M

0

Expert Reply:

Sure thing, take a look at the Malone Rack Pads for Crossbars # MPG314.

These rack pads measure 25" long, 4" wide, 2" tall, and will also fit round, square, smaller oval, aero, and elliptical crossbars.

I have also included a review video for you to check out as well.

expert reply by: Bryce D

0

Answer 1

Good morning, Donna. So, according to Malone, the #MPG217 roof rack does not fit the factory raised side rails on a 2017 Ford Explorer. I would have to offer you a different roof rack for this vehicle like the Rhino Rack #RR98VE. You can use a Malone…

view full answer...

Answer 2

Since you intend to one day pull a travel trailer I recommend the Tekonsha T-One Vehicle Wiring Harness with 7-Way Trailer Connector #118272 on your 2018 Ford Explorer. The travel trailer will likely require a brake controller due to the weight of…

view full answer...

Answer 3

You will need one of our Gen-Y stacked receivers to have multiple receivers capable of more than 500lbs of tongue weight. The Gen-Y Rebel X Ball Mount #GY39VR is capable of 6" of drop and the Rebel X #GY99VR is capable of 7-1/2" of drop.…

view full answer...

Answer 4

Finding a ladder rack that is compatible with a tonneau cover is always tough, but I have a great solution for you! I recommend going with the Thule TracRac SR #TH43003XT-510 (6-1/2ft bed) or #TH43003XT-010 (8ft bed). The Thule TracRac is a sliding…

view full answer...

Answer 5

The Inno crossbars part #IN436L are the exact same dimensions as the Malone bars so this would work on your Microsport trailer that has shorter bars to extend them out to 79 inches.

view full answer...

Answer 6

The Yakima OverHaul HD Ladder Rack #Y01151-5955 is compatible with Retrax XR, Pace Edwards UltraGroove, or Ford Embark LS tonneau covers. If you're set on using this ladder rack, or already have it, I recommend the RetraxONE XR Hard Tonneau Cover…

view full answer...

Answer 7

The lowest setting of the Erikson Big Bed Load Extender #EM07600 is 18" in height while the lowest setting of the Yakima LongArm Truck Bed Load Extender #Y01149 is measured at 17" high. That will still bring you at an inch higher than your…

view full answer...

Answer 8

Increasing tire width will not really benefit you in any significant way. You would see a slight increase in stability, but if the trailer already rides pretty straight, you may not see any improvement. The 5.30-12 tires would also make the trailer…

view full answer...

Answer 9

Your 4-pin/5-wire wiring harness is what is called a "wishbone" type which simply means that there are two separate running light wires, one brown and one pink. This allows a separate running light wire for each side of the trailer which…

view full answer...

Recommended Kayak Rack Pads For A Kayak Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching