Panel Dimensions of Go Power Solar AE-4 All Electric System with MPPT Solar Controller

Question

Question:

What are the size of the panels? The size listed seems small for wattage listed.

asked by: David M

0

Expert Reply:

Each of the panels of the Go Power Solar AE-4 All Electric System with MPPT Solar Controller # 342-75010 measure 59-1/8" long x 26-5/16" wide x 1-1/2" deep.

expert reply by: Jameson C

0

Answer 1

As-is the Go Power Solar AE-4 All Electric System with MPPT Solar Controller #342-75010 can be used with a lithium battery. At one point it could not.

view full answer...

Answer 2

The Go Power Solar Panels that we offer such as the Go Power Overlander Solar Charging System with Digital Solar Controller part #34282181 are linked together using MC4 cables. These cables are available using the Go Power MC4 Output Cable with…

view full answer...

Answer 3

We can get you set up with everything you need with the solar panels, 60 amp solar controller, and 3,000 watt inverter charger. That said, the solar panels we offer are 190 watt and not 200 watt, so a total of 760 watts. That said, the solar kit and…

view full answer...

Answer 4

Our highest rated solar panel kit is the Go Power AE-6 part #342-75011 which is rated for 1,140 watts. Each of the panels comes with wiring that runs to the controller so you would not need to supply that. Typically 10 gauge wire would be good.

view full answer...

Answer 5

There are many variables to determine how long your batteries will last. I have included a link to provide you information on how to calculate your run time, if you have enough information. Right away we have a road block as the manufacturer of the…

view full answer...

Answer 6

If you have an RV that was prewired by the OEM at time of build, it is almost that easy. It also depends on what type of system you want, mounted or portable and where is the factory installed plug located, roof or on the side of RV for a portable?…

view full answer...

Answer 7

I attached a diagram that shows how Go Power intended for the panels of the Go Power Solar AE-4 All Electric System with MPPT Solar Controller #342-75010 to be wired. Is there a reason you are wanting to wire them up differently? Changing the voltage…

view full answer...

Answer 8

There's going to be two ways to wire your Go Power Industrial Pure Sine Wave Inverter #34275013 but the transfer switch you have between the shore power and generator power is going to stay how it currently is. The internal transfer switch is…

view full answer...

Answer 9

The additional port on the side of the trailer is not run through the solar controller but directly to the battery/batteries. This port is actually designed for a portable kit which already has a built-in solar controller so you are perfect to go…

view full answer...

Answer 10

From what you have described as your goal, my suggestion is one of two primary options, and I will note here that with either option I suggest you have a battery bank of at least 400 AH when fully charged. This first option is not an automatic…

view full answer...

Answer 11

I recommend using the Go Power Industrial Pure Sine Wave Inverter Charger #34275013. This will reduce all the components into one system by combining your transfer switch inverter and converter/charger into one unit. You will be able to wire in your…

view full answer...

Answer 12

A lot of this depends on how much power your refrigerator uses and the size of your battery. I'll also add that you're likely not going to be able to accomplish running the fridge completely on solar power with only 1 battery and you're…

view full answer...

Panel Dimensions of Go Power Solar AE-4 All Electric System with MPPT Solar Controller

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching