Replacement Grease Seal For Jetski Trailer With 38.1 & 50.29 Stamped On The Seal
Question:
I’m looking for a Jetski trailer bearing seal. The only number i see on the old seal are 38.1 and 50.29 are you able to look up a part number using those ? Thanks
asked by: Daniel H
0
Expert Reply:
The numbers on your current grease seal sounds like a measurement in mm. That would give you a 1.5" inner diameter and 1.98" outer diameter. The Grease Seals # RG06-020 match that same measurement and fit a 2,000lb axle that is generally found on trailers like your Jetski trailer.
You can always measure the seal with a Digital Caliper # PTW80157 to verify that this is the correct seal.
expert reply by:
Bud M
0
Products Referenced in This Question
4" Carbon Fiber Digital Caliper
- Hand Tools
- Measuring and Layout Tools
- Digital Calipers
- Carbon Fiber
- Performance Tool
more information >
Product Page this Question was Asked From
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.500 Inch I.D.
- 1.987 Inch O.D
- TruRyde
more information >
Continue Researching
- Q&A: Towing a Trailer with Electric Brakes with a Semi Tractor with Air Brakes
- Q&A: Where to Find VIN/Serial Number on Boat Trailer
- Article: How to Charge a Dump Trailer Battery
- Q&A: Replacement Fulton Winch Strap Measuring 1-7/8 Inches by 14 Feet Long
- Q&A: Replacement for Atwood 70254 RV Landing Gear Switch
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Tire and Wheel Size to Replace 18.5x8.5-8 on Trailer
- Article: How to Use a Roof Rack (Like a Boss)
- Article: Trailer Maintenance Schedule
- Article: Roadmaster Vehicle Specific Base Plates
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)