What Gauge Wire is the Hopkins Endurance Multi-Tow 4-Way Flat to 7-Way RV Trailer Adapter # HM47180?

Question

Question:

What gauge wire is used in the pigtail with #HM47180

asked by: Zach

0

Expert Reply:

I went out to the warehouse and pulled the Hopkins Endurance Multi-Tow 4-Way Flat to 7-Way RV Trailer Adapter item # HM47180 off the shelf. The brake controller wire is 16 gauge the other three wires in the pig tail are 12 gauge.

expert reply by: Jerred H

0

Answer 1

The ground wire on a trailer's wiring harness (usually a white wire) should be firmly attached to clean bare metal on the trailer frame. The white ground wire on the vehicle's wiring harness should similarly be attached to clean bare…

view full answer...

Answer 2

We have something almost identical to the 47188. It is the Hopkins Endurance item #HM47180. This adapter also has a 4-way and 7-way wiring harness and the built in bracket. It connects to vehicles with a 4-way connector the same way too. I have…

view full answer...

Answer 3

Personally, I'm a much bigger fan of Pollak than I am of Hopkins. In my experience, I've had fewer issues with 7-way plug fitting loosely with Pollak brand 7-ways and Pollak is generally the "go-to" brand for most…

view full answer...

Answer 4

I verified for you the correct 4-way trailer wiring harness for your 2024 Subaru Ascent is the following: - Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C56040

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

It sounds like you are looking for the wiring harness portion of the Hopkins Endurance Multi-Tow 4-Way Flat to 7-Way RV Trailer Adapter part #HM47180. If that is the case then this part is not available separately but you can obtain something similar…

view full answer...

Answer 7

I went to the warehouse and took some measurements of the Hopkins Endurance Trailer Adapter, part #HM47180 for you. The White ground wire is 14-inches long. The Red, Blue, and Purple wire measure 8-inches long, and the 4-way harness also measures…

view full answer...

Answer 8

I wish that was possible, but you'd have to buy the #HM40975 separately if you wanted that style of connector instead.

view full answer...

Answer 9

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

What Gauge Wire is the Hopkins Endurance Multi-Tow 4-Way Flat to 7-Way RV Trailer Adapter # HM47180?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching