Parts Needed For an Over-Under Kit For a 4" Diameter 9,000 lb. Axle
Question:
What kit part number will fit an an axel size 4.00 inch diameter?
asked by: Lloyd J
Expert Reply:
I do have an option for you but a 4" diameter axle is a 9,000 lb. axle. We do not have any over under kits for a 9,000 lb. axle. We can however piece together the parts that you would need.
- Replacement U-Bolt w/Locknuts for 9,000-lb, Round Trailer Axles # 11-64 (you need 4)
- U-Bolt Plate for 4" Diameter, Round Trailer Axles # 12-42 (you need 2)
- Spring Seat for Typical 9,000-lb, Round Trailer Axles # 3-51 (you need 2)
This would be enough for 1 axle, so if you have multiple axles then you will need a set for each axle. If your U-bolts and U-bolt plates are still in good condition you can reuse them and just pick up the spring seats. But we recommend replacing the U-bolts and U-bolt plates because they often times get damaged during removal.
Products Referenced in This Question
U-Bolt Plate for 4" Diameter, Round Trailer Axles with 2" Wide Springs
- Trailer Suspension Parts
- U-Bolt Plates
- Camper
- Car Hauler
- Utility Trailer
- 9000 lbs
- Round Axle - 4 Inch
- 5/8 Inch Diameter
- Dexter
more information >
Spring Seat for Typical 9,000-lb, Round Trailer Axles with 4" Diameter
- Trailer Suspension Parts
- Spring Seats
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Round Axle - 4 Inch
- Redline
more information >
Product Page this Question was Asked From
Replacement U-Bolt w/Locknuts for 9,000-lb, Round Trailer Axles - 5/8" Diameter
- Trailer Suspension Parts
- U-Bolts
- Camper
- Car Hauler
- Utility Trailer
- 9000 lbs
- Round Axle - 4 Inch
- 5/8 Inch Diameter
- 8-1/8 Inch Long
- Redline
more information >
Continue Researching
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Proper Position of Equalizer and Shackles on Trailer Suspension
- Q&A: Replacement for P10490 Grease Seal
- Q&A: Replacement U-Clamp and Split Bushing For Roadmaster Front Sway Bar 1209-100
- Q&A: Grade of U-Bolt in the U-Bolt Kit APUBR-1
- Q&A: Height of Bulldog and the Powered-Drive Trailer Jack, # BD500187, from Bracket to Top of Jack
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Q&A: Clearance Required Around Rear Jacks of Lippert Ground Control 3.0
- Q&A: How Long Does It Take To Install Stay-In-Play DUO SM99251
- Article: Replacement Automotive Lighting
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)