Troubleshooting A MaxxAir 5100K Remote That Is Not Operating The Fan

Question

Question:

I have a MaxxAir 5100K all the controls on the fan work I have had it for about 6 months and just tried to use the remote which hasnt been used at all until a couple days ago. The remote buttons all work battery level is good but it is not connecting to the fan.

asked by: Chris

0

Expert Reply:

Since you've already verified the batteries are good, and that the buttons on your MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat # MA00-05100K are working properly, then you may just have a bad remote.

To replace your remote, you can use the:

-Replacement Handheld Remote for MaxxAir Roof Vent Intake/Exhaust Fans # MA00A01150K.

You'll also want to verify that your remote has clear line of sight to the fan and that nothing is blocking the sensor on the fan.

expert reply by: Bryce D

0

Answer 1

The circuit board of your MaxxFan might need to be reset. If you can cut power to the fan by pulling a fuse I'd try that first. If that does not work then there would be an issue with the circuit board and you'd want to replace it with the…

view full answer...

Answer 2

To replace the manual lift operator on your MaxxAir 5100k #MA00-05100K you'll want to use the Replacement MaxxAir Roof Vent Manual Lift Operator #MA10-20281K-3CF.

view full answer...

Answer 3

For your MaxxFan RV roof vent part #MA00-05100K the correct replacement circuit board is the #MA10A21276K.

view full answer...

Answer 4

14.2-14.4 volts will not destroy the MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat #MA00-05100K, however anything over 13.8v can cause the fan to shut down on the limit switch.

view full answer...

Answer 5

Yes, having heavier gauge wire than needed won't be an issue at all when installing the MaxxFan Deluxe RV Roof Vent part #MA00-05100K. It's only an issue if it's the opposite situation where the wiring is too thin.

view full answer...

Answer 6

The Swagman Patrol 2 Bike Rack for Truck Beds #S64701 is a confirmed fit for your 2011 Ford Ranger and if you check out the picture I attached you can see it installed over at truck's bed rail cover. You can also see the entire install process in…

view full answer...

Answer 7

The MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat, #MA00-05100K is a manual lift 10 speed ventilation fan that is reversible and can be in the opened position without the fan running.

view full answer...

Answer 8

If your MaxxFan Plus Roof Vent #MA00-04000K isn't responding at all to the remote then most likely it just needs to be replaced with part #MA00A01150K or the batteries are just in need of a change. I do also recommend verifying that you're…

view full answer...

Answer 9

The Replacement Handheld Remote #MA00A01150K will work with your MaxxAir 8500K fan you already have. The remote is optional and not listed in our description for 8500K fan. To use the remote you will simply turn on the remote and it will communicate…

view full answer...

Answer 10

I spoke with my contact at MaxxAir who said that if you lost the remote to your MaxxAir fan there is no programming that has to be done when using a replacement remote. Part #MA00A01150K is already compatible with all MaxxAir fans that have…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Troubleshooting A MaxxAir 5100K Remote That Is Not Operating The Fan

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching