Parts Needed To Install Trailer Brake Controller On a 2006 Saturn Vue With 4-Way Flat Connector
Question:
I have Two Saturn Vues 2004 and 2006 Front Wheel drive 3.5 engines. Bought Trailer with brakes. Would like to buy the Curt Echo Wireless Trailer Brake Controller - 1 to 2 Axles - Proportional so I can switch from each SUV. I have 4 pin currently on each SUV. There For Need wires and plug in to Saturn Brakes to run back to rear of vehicles. And 4 pin to 7 pin which has 3 wires that need to run to front of vehicle to hook to battery and brakes. Second question Also I was told that you could bypass brakes pedal and hook directly to brake lights? Is that correct or not recommended. Thanks.
asked by: Stephen T
Expert Reply:
As you already have the 4-way flat connectors on your two Saturn Vue's you will only need a 7-Way RV Upgrade Kit for Trailer Brake Controller Installation # ETBC7L for each vehicle. This will provide you with the 7-way that connects to your 4-way and has the wiring for running power to the 7-way charge line.
The Curt Echo Wireless Trailer Brake Controller # C51180 works differently from other brake controllers. It is powered by the charge line on the 7-way circuit. It uses the input from the brake/turn signal wires on the circuit to tell the brakes when to apply so there is no need to tie into the brake switch on your Vue.
Products Referenced in This Question
7-Way RV Upgrade Kit for Trailer Brake Controller Installation - 12 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
- Trailer Brake Controller
- Proportional Controller
- Hidden
- Up to 2 Axles
- Smartphone Display
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Does HBA-CAM Adapter Module for Hydrastar Electric Over Hydraulic Brake Actuators have 2 or 4 Wires
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Curt Echo Full Review
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How To Setup a 2019 Jeep Cherokee Trailhawk for Flat-Towing
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box