How Many Pins Does Hopkins Smart Hitch Backup Camera and Hitch Aligner System Connector Have
Question:
Hopkins Smart Hitch Backup Camer The connector to the monitor is that a 6,7,8 pin. connector thank you
asked by: Joseph R
1
Helpful Expert Reply:
The Hopkins Smart Hitch Backup Camera and Hitch Aligner System # HM50002 that you referenced uses an 8 pin connector between the monitor and the camera.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Hopkins Smart Hitch Backup Camera and Hitch Aligner System
- Backup Camera
- Hitch Alignment Camera Systems
- Hardwired
- Dash Monitor
- 3.5 Inch Display
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Wiring Harness Recommendation for 2017 Lexus RX 350 with Towing Package
- Q&A: Does The LaSalle Bristol RV Roof Membrane Ship Folded Or Rolled Up
- Q&A: LaSalle Bristol XTRM Roof Membrane Install Kit Recommendation
- Q&A: Replacement Grease Seal 225255UC for 2015 Wesco Trailer
- Q&A: Correct Replacement Oil Seal 225255UC for Ranger Boat Trailer
- Article: How to Survive the Winter In Your RV
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: My Firestone Compressor Keeps Running Even When Air Bags Are Full
- Q&A: What Size Wire Gauge is Used in Vision X 9007 Halogen Headlight Bulbs with Relay Harness
- Article: How to Measure for Trailer Hitch Drop
- Article: Performance Chips and Modules
- Article: Trailer Wiring Diagrams