Brake Controller for 2021 Honda Ridgeline With Factory 7-Way to Tow Pop-Up Camper

Question

Question:

I have a 2021 Honda Ridgeline that has the 7 pin round RV plug installed from the factory and looking to buy a pop-up camper that has a brake axle on it. What do I need to use the brakes on the camper?

asked by: Mark

0

Expert Reply:

I recommend the Redarc Tow-Pro Elite Trailer Brake Controller, # RED44FR installed using the Plug-In Wiring Harness # RED59FR.

It is a simple, rugged, straight forward proportional brake controller, making a a top seller for a proven reason.

expert reply by: Michael R

0

Answer 1

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 2

From a wiring perspective all you need to install the Redarc Tow Pro Elite part #RED44FR in your 2020 Honda Pilot is the part #RED59FR. I am not sure what size the blanks of your vehicle are so I can't pick you one out, but one solution could be…

view full answer...

Answer 3

Yes. The RedArc Tow Pro Liberty #RED24FR is a great choice since it installs out of the way and provides you with proportional braking for your tandem axle trailer. You'll want to use the Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

view full answer...

Answer 6

Installation of the Curt T-Connector Vehicle Wiring Harness with 7-Way Trailer Connector, #CU86FR feeds through the bottom of the vehicles cargo area by removing the rubber grommet. See the attached image. I have linked an installation video of this…

view full answer...

Answer 7

Since you already have a 4-way connector on your 2018 Toyota Highlander you need to use one of our adapter kits to convert it to a 7-way. If the trailer doesn't have brakes you only need to power its lights and the battery so you can use part…

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 12

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Brake Controller for 2021 Honda Ridgeline With Factory 7-Way to Tow Pop-Up Camper

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching