Installation of the Valterra Bladex Waste Valve Body for RV Black Water Tank
Question:
the series of pictures on you sight of the valve closed shows daylight on either side of the blade with the blade closed, cant expect it to hold back water. or is the seal not installed?
asked by: Daniel R
0
Expert Reply:
The image on the sight you refer to is of an uninstalled valve body, once the tubing is in place it will be sealed. When the Valterra Bladex Waste Valve Body for RV Black Water Tank, # T1003VPM, is properly installed there will not be any leaks.
expert reply by:
Michael R
0
Product Page this Question was Asked From
Valterra Bladex Waste Valve Body for RV Black Water Tank - Aluminum Handle - 3" Diameter
- RV Waste Valves
- Straight Valve
- Single Waste Valve - Manual
- 3 Inch Valve Body
- Stationary Valve
- Valterra
more information >
Continue Researching
- Article: Trailer Maintenance Schedule
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: Updated Retainer Clips # KOD24FR For Kodiak Disc Brake Calipers
- Q&A: Recommended Dexter Electric Drum Brakes for 4000-lb Axles on 5th Wheel Trailer
- Q&A: Replacement Control Panel for Atwood Water Heater with AVM93256 Control Panel
- Q&A: Replacement Center Cap for a 2007 StarCraft Antigua Camper
- Q&A: Motor On MaxxAir MaxxFan 4900K Roof Vent Will Not Shut Off When Lid Is Closed
- Q&A: Measurements of Valterra Waste Valves
- Article: How to Drain an RV Water Heater
- Article: Best RV Roof Vents
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting
- Article: Trailer Wiring Diagrams
- Article: Must-Have Flat Towing Components
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing