Replacement Damper For Ventline RV Range Hood
Question:
I lost the damper/flapper on the outside of our RV in transit. Measurements for the opening are 10 3/4 inches X 4 inches. I dont know the model of the vent itself. Could you recommend a replacement part. And if its too large, can they be trimmed to size?
asked by: Jeremy S
Expert Reply:
I took a look at what you're looking for, and the closest I was able to get to match the measurements you need is the:
-Replacement Damper for Ventline RV Range Hood w/ Horizontal Exhaust # BCA0472-00.
This damper has an overall length of 10-1/4", and a width of 4-3/8".
As far as trimming is concerned, it is not recommended or advised to modify this part, as it isn't designed to and may not work as intended.
Product Page this Question was Asked From
Replacement Damper for Ventline RV Range Hood w/ Horizontal Exhaust
- Accessories and Parts
- RV Range Hoods
- RV Vents and Fans
- Range Hood
- Damper
- Ventline
more information >
Continue Researching
- Q&A: Install Instructions Link for Lippert Lift Kit # LC382741
- Q&A: Torque of Mounting Nuts on Lippert Torsion Axle Lift Kit
- Article: Double-Eye Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Q&A: Where to Measure on Trailer Spindles to Determine Replacement Hubs
- Article: How to Raise Your Travel Trailer Height
- Q&A: Ventline Pinnacle RV Range Hood Amperage Draw
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Size Hardware Should Be Used With the Super Titan Forged Pintle Hook Plate
- Q&A: Will the Pintle Hook # 63015 Attach to the Super Titan Pintle Hook Plate # RP38186
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements