How to Remove Lens From Command LED Trailer Tail Lights # 328-003-85L and # 328-003-85

Question:

Replacement instructions needed. Looks like it’s sealed in place but no obvious screws or other atta

asked by: Frank S

Expert Reply:

The LED Trailer Tail Light w/ Reflector for the Drivers Side # 328-003-85L and Passenger Side # 328-003-85 have small notches on the lens that hold it in place. A Pick Set # PT76VR will allow you to get behind the lens to pry the lens off of the tabs as seen in the image below. If your lens was sealed in place you may be able to pull some of the sealant away from the lens with a sharp razor or scraper designed for sealants.

If the sealant or adhesive was used to secure the lens to the backing plate you will likely need to destroy the lens to remove it. As we do not have any replacement lenses for these lights you will need to replace the entire assembly.

There will be 4 screws around the outer edge of the light that allow you to remove the backing plate from your trailer and disconnect the wiring.

expert reply by: Bud M