Anti-Sway Bars For 2022 Thor Vegas 24.3 Class A Motorhome on Ford E350 Chassis

Question

Question:

Hello, I just bought a 2022 Thor Vegas 24.3 and looking for anti-sway bars. Please advise, thank you!

asked by: Clarence R

0

Expert Reply:

I checked directly with Roadmaster for you to verify the fits of the anti-sway bars for your 2022 Thor Vegas 24.3 Class A motorhome on a Ford E350 chassis, and the correct fits are the following:

- Roadmaster Rear Anti-Sway Bar # RM83ZR

- Roadmaster Front Anti-Sway Bar # RM-1139-176

You made a really smart choice going with anti-sway bars, as they are the best way to enhance the ride of your '22 Thor Vegas 24.3. The bars act as a brace between the frame of your motorhome, and are better constructed with higher-strength, thicker steel than OEM sway bars, giving them a much higher roll stiffness to combat sway.

expert reply by: Kyle S

0

Answer 1

The correct weight capacity SumoSprings system for your 2020 Jayco Melbourne will depend on how much support you are looking for. If you are not getting a lot of body roll and just need a little support, go for the 900 pound #SSR-338-47. On the…

view full answer...

Answer 2

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 3

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the…

view full answer...

Answer 4

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 7

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 12

I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…

view full answer...

Anti-Sway Bars For 2022 Thor Vegas 24.3 Class A Motorhome on Ford E350 Chassis

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching