Ramp Springs for a Trailer with Two 8' Ramps
Question:
I have 8 foot ramps on the back of our trailer. I need heavy duty springs for the ramps to lift.
asked by: Betty F
0
Expert Reply:
It sounds like you have a utility/equipment trailer with two 8' ramps. The only springs that we have that will work for that style are the Ramp Spring - 2K Torque for 1-1/2" Shaft # RS16933RH (for Right Hand) and # RS16933LH (for Left Hand). These springs will work with shafts that are 1-1/2" and they have 2,000 lbs. of torque.
I have included a video that reviews these springs and shows an installation for you to check out.
expert reply by:
Scott S
0
Products Referenced in This Question
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Trailer Ramp Springs
- Single Ramp Spring
- Right Hand Spring
- 10 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can Trailer Tire Size 175/80-13 Replace Size 185/80R13
- Q&A: Horse Trailer Ramp Spring For Helping Lift Heavy Ramp
- Q&A: Trailer Tire and Dual Wheel Recommendation for 10K Dexter Axle
- Q&A: Trailer Ramp Springs for a 20 Ton Tandem Axle Trailer
- Q&A: Determining Axle Length for 6 Foot 6 Inch Wide Trailer
- Q&A: Replacement Boat Trailer Seal for a NOK AD2527E Grease Seal
- Q&A: Replacement Hub for Hammer Blow Hub Part HB732 on Old Trailer
- Article: Trailer Maintenance Schedule
- Article: Best RV Roof Vents
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: Troubleshooting Brake Controller Installations
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams