Slide Out Awning Recommendations For A 2022 Salem Hemisphere 356 QB

Question

Question:

Hello, We are proceeding with the purchase of a 2022 Salem Hemisphere 356QB fifth wheel RV with 4 slide-outs. This RV come with slide-topper factory installed awning rails and brackets on the RVs slide out walls. Outermost width dimensions of each slide-out: • Main slide-out: 153.5 in • Master bedroom slide-out: 78.5 in • Outdoor kitchen slide-out : 83.5 in • Bunk slide-out: 83.5 in This would be our main improvement project for next year. Would you be kind to provide me with the associated Solera RV Slide-Out Awning size and model number required for each slide-out? Thank you Henri Levasseur

asked by: Henri L

1

Helpful Expert Reply:

When it comes to choosing the correct slide out awnings for your 2022 Salem Hemisphere 356 QB we have some options for you. For the main slide-out I would recommend The Solera RV Slide-Out Awning - 13 foot 1 inch Wide - 48 inch Projection - White # LCV000163300 or the black awning # LCV000168109. They will fit anywhere between 152 inches wide to 157 inches wide. They have a simple installation with included brackets, hardware, and awning rail. The material is constructed with heat-welded seams to prevent water leakage.

For the master bedroom slide out The Solera RV Slide-Out Awning - 6 foot 7 inches Wide - 48 inch Projection - Black # LCV000168105 or the white version # LCV000163285 will fit anywhere between 74 inches wide to 79 inches wide and extends 50 inches.

For the outdoor kitchen slide out The Solera RV Slide-Out Awning - 7 foot 1 inch Wide - 48 inch Projection - Black # LCV000165062 or the white version # LCV000163287 will fit anywhere between 80 inches wide to 85 inches wide, and extends 50 inches. The same will work for your bunk slide out as well.

I will attach an installation video link below of the awnings being installed on a different fifth wheel RV but it will be the same installation process.

expert reply by: Noah E

1

Answer 1

I have found with a lot of the older campers like your 1995 Prowler that the screen doors are installed lower so it creates an issue when closing. Unfortunately there aren't a set of steps like the SolidStep Manual Fold-Down Steps that…

view full answer...

Answer 2

We've seen this issue before on an older camper that had the screen door installed a little lower than how they are now. An installer here actually had this exact problem. If your door is close to closing, a couple suggestions that you can try…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 5

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 6

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 9

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Slide Out Awning Recommendations For A 2022 Salem Hemisphere 356 QB

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching