Battery Charge Line to Maintain the Battery Charge on a 2019 Jeep Wrangler When Being Flat Towed

Question

Question:

My jeep wangles battery has low voltage after being towed. I have a Demco Stay in play brake. What DC to DC charger do I need?

asked by: Tom M

0

Expert Reply:

We do have what you need, while technically the Demco SBS Stay-IN-Play DUO # SM99251 does not "require" a charge line, it is still a good idea to add one. Especially given the fact that you are experiencing low battery voltage after towing.

You can use the Roadmaster Battery Charge Line Kit for Towed Vehicles # RM-156-25 to maintain the battery charge in your Wrangler while it is being towed. This kit simply uses your wiring connection from your motorhome to maintain your vehicle battery so that it is never depleted. Most motorhomes already have the 12V charge line, but if not, you can use the Roadmaster Battery Charge Line Kit for Motorhomes # RM-156-75 to add one.

expert reply by: Scott S

0

Answer 1

The first thing you need to flat tow your 2019 Mini Countryman is the Blue Ox base plate kit part #BX1312 that you referenced which fits the manual transmission models. In addition to the base plates, you will also need a compatible tow bar, safety…

view full answer...

Answer 2

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 5

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 6

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 7

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 8

A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…

view full answer...

Answer 9

It really just depends on what the wires are for. Most likely you have several ground wires among the 8 as well as a couple running light circuits in there as well. You just have to run all of the wires to the correct circuits. The 4-way wiring of…

view full answer...

Answer 10

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Battery Charge Line to Maintain the Battery Charge on a 2019 Jeep Wrangler When Being Flat Towed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching