How to Install MORyde StepAbove RV Steps with a Door that has a Gas Strut Obstructing Clearance
Question:
I measured the entry 24 and the height from threshold to ground 32. The MR98RR would be perfect, but how do we work around that shock rod installed on the right side of the threshold for the door?
asked by: Kimberly C
Expert Reply:
If you are wanting to install the MORryde StepAbove RV Steps # MR98RR you would need to remove the shock rod/gas strut because it will interfere with the step clearance. You can use the Replacement Controlled Motion Hinge for RV Entry Door # LC95VR (black) or # LC22NJ (white) on your RV door which uses Controlled Motion Technology to hold the door open in any position instead of allowing the door to swing freely. This will work with Lippert RV doors as an alternative to a shock rod/gas strut.
Products Referenced in This Question
Replacement Controlled Motion Hinge for RV Entry Door - 6 Leaf - White
- RV Door Parts
- Entry Door
- Hinges
- Controlled Motion Hinge
- White
- Lippert
more information >
Replacement Controlled Motion Hinge for RV Entry Door - 6 Leaf - Black
- RV Door Parts
- Entry Door
- Hinges
- Controlled Motion Hinge
- Black
- Lippert
more information >
Product Page this Question was Asked From
MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways - 3 Steps
- RV Steps
- Towable Camper
- Fold-Down Step
- 19-1/2 Inch Wide Step
- 22-1/4 Inch Wide
- 3 Steps
- 8 Inch Drop/Rise
- Ground Contact
- Aluminum
- MORryde
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Replacement Entry Door Hinge for RV - 6 Leaf - White
- Search Results: lippert hinge
- Search Results: trailer light box
- Search Results: trailer lights
- Search Results: roof box
- Search Results: trailer ball
- Search Results: trailer wire
- Search Results: internal thread ball
- Shop: Buyers Products Tail Light Mounting Box - 6" Oval Hole - 2" Round Hole - Black Steel
- Shop: 1-7/8" Hitch Ball with Internal Thread - 3/4" Diameter x 2" Long Shank - Chrome - 2K
- Shop: Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diode - Oval - Red Lens
- Shop: Rubber Grommet for 2-1/2" Round Trailer Lights - Flush Mount - Open Back
- Shop: Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Shop: PVC Grommet for 6-1/2" Oval Trailer Tail Lights
- Q&A: Installation Instructions For The Lippert Controlled Motion Hinge For RV Entry Door
- Video: Review of Lippert RV Door Parts - Entry Door Hinge - LC95VR
- Q&A: How To Install a Gas Shock/Strut On a RV Door That Never Had One
- Q&A: Troubleshooting MORryde Step Above that Won't Allow Door to Close
- Q&A: Ways To Keep Entry Door On Keystone Outback Travel Trailer From Slamming Open & Closed due to Wind
- Q&A: Can the Controlled Motion Hinge for RV Entry Door Be Used in Place of a Gas Strut
- Q&A: Replacement Door Hinges for a 2019 Forest River Sandpiper 5th Wheel
- Video: Review of Lippert Components RV Doors - Entry Door - LC198295
- Q&A: How Do Rear Jacks of Lippert 6.0 Ground Control Fit with Slide Out Cross Shaft
- Video: Choosing the Right Trailer Wiring
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Fifth Wheel Hitch