Wiring Connections For Bright Way Push-to-Test ICU Trailer Breakaway Kit # BW94FR
Question:
i am replacing a brightway charging breakaway box without the ICU/alarm/flashing light system with the brightway charging system with the alarm. So i am going from a 3 wire breakaway box white red and blue to a 4 wire breakaway box white red blue and black. What is the black wire for? what do i hook it to? maker lights brown wire? thanks
asked by: Bill
Expert Reply:
I have added an image below for the Bright Way Push-to-Test ICU Trailer Breakaway Kit # BW94FR as well as an installation video that is also very helpful. Here is where all the wires will connect from both the battery box and the breakaway switch.
Battery Box
White- Ground Wire(white)
Red- 12 Volt Charge Line(red or black wire)
Blue- Breakaway Blue Wire
Black- Running Lights(brown wire)
Breakaway
Blue- Battery Box Blue Wire
Black- Trailer Brake Wire(blue or black wire)
Four of the Deka Ring Terminals # DW05737-1 will make connecting the wiring inside your junction box much easier.
Products Referenced in This Question
Deka Ring Terminal - Heat Shrink - 16-14 Gauge - 1/4" Ring ID - Nylon Insulation - Blue - Qty 1
- Wiring
- Wire Connectors
- Ring Terminals
- 1/4 Inch Diameter
- 16-14 Gauge
- Deka
more information >
Product Page this Question was Asked From
Bright Way Push-to-Test ICU Trailer Breakaway Kit with 0.5-Amp Charger and 5 Ah Battery - Side Load
- Trailer Breakaway Kit
- Kit with Charger
- Single-axle
- Tandem-axle
- LED Tester
- .5 Amp Charger
- Battery Included
- 5 Ah
- Bright Way
more information >
Continue Researching
- Shop: Bright Way Push-to-Test ICU Trailer Breakaway Kit with 0.5-Amp Charger and 5 Ah Battery - Side Load
- Q&A: Wiring Diagrams for Installing Bright Way Trailer Breakaway ICU Kit # BW94FR
- Search Results: spare tire lock
- Shop: etrailer Spare Tire Lock for 1/4" to 7/8" Thick Rims - Keyed Alike
- Video: Review of Bright Way Trailer Breakaway Kit - Kit with Charger - BW94FR
- Shop: Bright Way Push-to-Test Trailer Breakaway Kit with 1-Amp Charger and 5 Ah Battery - Side Load
- Search Results: redarc
- Article: Trailer Wiring Diagrams
- Video: Roadmaster Hy-Power Diode Review
- Video: Optronics Load Resistor for LED Lights Installation
- Video: Review of Roadmaster Tow Bar Wiring Diode - RM-790
- Shop: Optronics Load Resistor for LED Lights - Male PL-3 Plug and Female PL-3 Plug - Qty 1
- Shop: Roadmaster Hy-Power Diode - (Qty 1)
- Shop: Vehicle Cargo Control
- Shop: Tailgate
- Search Results: stake pocket d ring
- Search Results: spare tire lock bracket
- Shop: Brophy Stake Pocket Tie Down Anchor - Black Powder Coat - 3" D-Ring - 4,000 lbs
- Shop: Brophy Stake Pocket Tie Down Anchor - Black Powder Coat - 2-5/16" D-Ring - 4,000 lbs
- Search Results: seelevel
- Video: Bright Way Push-to-Test Trailer Breakaway Kit Review and Installation 3802308
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How To Wire the Thinline LED Trailer Tail Light STL64RB As a Third Brake Light
- Q&A: Can Optronics Thinline LED Trailer Tail Light be Used as a 3rd Brake Light
- Search Results: hot water
- Video: Review of Furrion RV Water Heaters - Replacement Wall Control Panel - FR48NR
- Search Results: 3 way switch
- Video: Review of JR Products Mini RV ON/OFF/ON Switch - 37213335
- Q&A: Wire Colors for Optronics Thinline LED Trailer Tail Light # STL64RB
- Q&A: Parts Needed to Install 3rd Brake Light on Enclosed Trailer