Clearing Fault Code and Manually Operating Lippert Ground Control 3.0 Electric Leveling System
Question:
Right rear jack will not raise We cannot clear the fault
asked by: Scott S
Expert Reply:
The Lippert Ground Control, # LC358590 can be reset/clear error codes by pressing the retract button and the enter button simultaneously. You will need to hold both for about 3 seconds to clear the error code. You can also try powering down the entire system and waiting a few minutes before reconnecting power. You must have a properly charged battery for the system to function properly.
In addition, you can manually retract the jacks:
Top of Jack Motor Override:
Tools needed:3/8” drive ratchet and extension (no socket)
1. Find the port on the top of the jack motor
2. Remove the rubber plug
3. Insert the 3/8” drive into the port
4. Turn override until the jack extends or retracts to desired position.
Bottom of Jack Motor Override:
Tools needed:3/8” drive ratchet and extension, 5/16” socket
1. Find the port on the bottom of the jack motor
2. Remove the rubber plug
3. Insert the 5/16” socket into the port
4. Turn override until the jack extends or retracts to desired position.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Can I Install a 4-Point Control Module to a 6-Point Lippert Ground Control and Only Use Four Jacks?
- Q&A: Which Snappads for 2025 Entegra Aspire
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Article: How to Raise Your Travel Trailer Height
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review