What Gauge Wire Should be Used when Installing 7-Way Kit ETBC7
Question:
do i use 10 gage wire to hook up to the wires that come out of the 7 pin plug
asked by: Tony
0
Expert Reply:
10 gauge wire should be used for the ground circuit, the brake output circuit, and 12 volt accessory circuit for 7-way wiring like with what comes with the # ETBC7.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Brake Controller Installation on 2016 Mercedes-Benz Sprinter
- Q&A: Tool for Adjusting Drum Brakes on Drop Axle
- Q&A: Does a 2022 Chevrolet Silverado 3500 Short Bed Need a Sliding 5th Wheel Hitch
- Q&A: Picking Between ETBC7 and ETBC7L for Brake Controller Install
- Q&A: What is the Difference Between a Class II and a Class III Hitch?