Air Bag Suspension Kit that Fits 2019 Ram 1500

Question

Question:

Which air bags are recommended for 2019 Ram 1500 new body 4X4? We tow a 6500lb horse trailer 3 times a month. Adding 2 leveling struts to front. Thank you.

asked by: Joseph O

0

Expert Reply:

For your 2019 Ram 1500 the air bag kit I recommend is the Air Lift part # AL88375 which has internal jounce bumpers in it. I attached an install video for this on a similar Ram for you to check out as well.

expert reply by: Jameson C

0

Answer 1

To install the excellent Tekonsha Prodigy P2 Trailer Brake Controller #90885 on your 2019 Ram 1500 you just need the Plug-In Wiring Adapter #3024-P. The factory brake controller port should be located underneath the dash, above and in front of the…

view full answer...

Answer 2

Yes, you can use the B and W Continuum #BW78FR an Air Lift air bag kit #AL88375 on your 2020 Ram 1500. You would want to first decide how much air pressure in the bags you want and then setup up the Continuum and you'd be set.

view full answer...

Answer 3

The only Air Lift Air Helper Springs available for your 2019 Ram 1500 Big Horn 2wd are the Kit #AL60828HD. The LoadLifter 5000 #AL88375 you found will only fit on 4wd trucks. The Springs #AL60828HD are rated for up to 2,100lbs of capacity which is…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 10

Yes, the best option we can offer you to add fuel capacity is with the DeeZee Truck Bed Auxiliary Tank part #DZ91752X which should fit in the space you have between the cab and 5th wheel hitch no problem as it is only 9" deep. I don't have…

view full answer...

Answer 11

As far as height adjustability and weight capacities the Curt Q20 #C16130 and the Curt A20 #C16140 are identical. They both have a Gross Towing Weight of 20,000 lbs, a Vertical Load Limit of 5,000 lbs, and a height range of 13-17 inches. When it…

view full answer...

Answer 12

To determine which brake assemblies would be needed, you will need to measure your existing brake drums as shown in the provided photo. Since your trailer has a 14,000 lb capacity, you most likely have tandem 7,000 lb axles, which typically use a…

view full answer...

Air Bag Suspension Kit that Fits 2019 Ram 1500

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching