How Tight Should Compression Fitting # D13032 Be when Installing a Transmission Cooler
Question:
Hi guys! With regards to the compression fitting installation, can you please tell me how tight I should tighten the crush nut and the barb fitting. Do I need to go all the way until no thread is left?
asked by: Sergei
Expert Reply:
Generally, you will tighten the fittings as much as you can with normal hand tools. If you then do a test after installation by starting the vehicle, check for leaks at the fittings. If you notice even a a drop of fluid leaking out then you will need to tighten them down further. Heat can make the metal expand so checking for leaks is important.
in the video I have linked you will see our installer using regular wrenches to tighten down the hardware. Notice that he is making the fittings tight but not over torquing anything, just making them tight.
Product Page this Question was Asked From
Derale Transmission Line Compression Fitting Kit - 3/8" Line to 3/8" NPT Barb
- Accessories and Parts
- Transmission Coolers
- Fittings
- 3/8 Inch NPT Hose Barb
- Derale
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Derale Transmission Line Compression Fitting Kit - 3/8" Line to 3/8" NPT Barb
- Q&A: Do the Fittings in Transmission Cooler # D12904 Require Thread Sealed Tape/Sealant When Installed
- Q&A: How to Determine Which Line is the Return Line for Installing Supplemental Transmission Cooler
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 44649
- Shop: Trailer Wiring
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Video: Choosing the Right Trailer Wiring
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Trailer Wiring Diagrams
- Search Results: 68149
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Video: Lippert Solera Slider Slide-Topper Review
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Shop: Grease Seals 10-36 (pair)
- Video: Choosing the Right Brake Controller
- Search Results: 25580
- Shop: Fifth Wheel Hitch
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Search Results: dust cap
- Shop: Gooseneck Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Search Results: dust caps
- Shop: Dust Cap for Kodiak Disc Brake Kit
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Video: Roadmaster Automatic Battery Disconnect Installation - 2020 GMC Sierra 1500