How Does Prodigy P3 # 90195 Install in 2017 Audi Q7

Question

Question:

Hi there, I have a Tekonsha P3 that was installed in a 07 Jeep Grand Cherokee, is it possible to move this controller to a 17 Audi Q7 by purchasing a new harness? If so which harness would work for the 17 Audi Q7 3.0 with factory tow package? Thanks,

asked by: Jason

0

Expert Reply:

You can install the Prodigy P3 part # 90195 in your 2017 Audi Q7 but you will need some wiring that you can only get at an Audi dealer. the brake control harness: (qty. 1) #1J0-972-782 housing and (qty. 2) #000-979-228 wire/terminal assemblies. Please see the tech bulletin link I attached to this page.

expert reply by: Jameson C

0

Answer 1

The Thule crossbar strip cover part #TH853354407 would work to cover your opening that is .45 inches wide. That is the diameter opening it was designed to fit.

view full answer...

Answer 2

I may have a solution for you. The Replacement Rubber Strip #TH853354407 is designed to fit into a channel that is 7/16 of an inch wide on the top and 7/8 of an inch wide at the bottom. I have included a diagram that shows these measurements. You can…

view full answer...

Answer 3

You likely have the Thule Aero load bars which take rubber strip #TH853354407 for 53 inches.

view full answer...

Answer 4

The Thule Replacement Rubber Strip #TH853354407 referenced in your question is designed to fit the Thule Aero Load Bars. To see if they might fit the channel on your Brightlines Crossbar, you will want to take a couple measurements. This particular…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 9

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 10

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 11

In regards to the Correct Track Trailer Alignment and Lift Kit part #RR23QX, the kit provides a lift by essentially extending the hangers. This normally requires cutting off the old hangers and welding on new, taller ones but with this kit you…

view full answer...

Answer 12

The Correct Track Trailer Alignment and Lift Kit part #RR23QX offers a 1-1/4" or 2-1/4"lift so if the hitch height height is lower than the vehicle hitch height you can use this kit to bring the trailer level with the vehicle and eliminate…

view full answer...

How Does Prodigy P3 # 90195 Install in 2017 Audi Q7

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching