What Width Channel Does Curt Hitch 13072 Fit
Question:
I am planning to use this on my 2005 Durango. However, I have frame rot and I am replacing the rear crossmember. I believe it is 2.5 inches square tubing, but am considering replacing with 3 inch square tubing. What size is the opening of this receivers channel? Thanks.
asked by: Victor M
1
Helpful Expert Reply:
The Curt hitch part # 13072 is designed to fit the factory 2-1/2 inch wide crossmember at the rear of your 2005 Dodge Durango.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 9000 lbs WD GTW
- 2 Inch Hitch
- 900 lbs WD TW
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: One Inch Wide Trim For Horse Trailer
- Q&A: When to Replace Dexter Nev-R-Lube Bearings
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Correct Replacement for AL-KO 7230 Hub/Drum and Brakes
- Q&A: Measurements Needed to Determine Replacement Bearings Without Having Old Bearings Numbers
- Q&A: Flat Tow Set Up for 2022 GMC Yukon XL
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Choose a Bike Rack for a Sedan or Hatchback
- Article: Rooftop Cargo Carriers
- Article: How to Measure for Trailer Hitch Drop