Additional Pipe Mounts For Pro Series Round, Pipe-Mount Swivel Jack # PS1401420303
Question:
I am looking to buy this jack but I need to order two more weld on pipe mounts for this jack. What size do I need to make this work?
asked by: Joseph M
0
Expert Reply:
You will need the Bulldog 2-1/4" Long, Weld-On Jack Pipe Mount # BD005005 to add additional mounting points for the Pro Series Round, Pipe-Mount Swivel Jack # PS1401420303. The pipe exterior diameter is 2" and the mount is 2-1/4" long.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Pro Series Round, Pipe-Mount Swivel Jack w/ Footplate - Sidewind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: What is the Estimated Installation Time for Firestone Ride-Rite Air Bags on a 2006 Ford F-250
- Q&A: Replacement Electric Brakes for Dexter PR-FF SEC-FF 5.2KPR-GGSEC-GG 12X2XQ 36-89
- Q&A: Replacement 12 inch Brake Assemblies for Dexter 36-89 on Trailer
- Q&A: Equalizer Replacement Options for Dexter 13-122 Equalizer
- Q&A: Comparing Equa-Flex and Road Armor Equalizers For 2000 Forest River WIldwood W/ 5200lb Axles
- Q&A: Can 12 Volt Battery Replace Two 6 Volt Batteries
- Q&A: Is a Master Key Needed to Install or Remove a Thule Lock Cylinder
- Article: How to Rent an RV
- Article: What Exactly is Tongue Weight?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings
- Article: How to Charge a Dump Trailer Battery
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft