Replacement Toilet Seat For Dometic 510 Full-Timer And Sealand Toilets

Question

Question:

do you have any replacement toilet seat lids for a dometic 510 series toilets.

asked by: Shelby

0

Expert Reply:

Yes, we do have a couple choices to choose from for your Dometic 510 Full-Timer toilet. The Replacement Wooden Toilet Seat and Lid for Dometic Full-Timer RV and Sealand Toilets # DOM85FR which is white in color or # DOM25FR which is tan in color.

Both of these toilet seats are confirmed to be a direct replacement for your Dometic 510 Full-Timer RV and Sealand Toilets.

expert reply by: Bryce D

0

Answer 1

The distance between the mounting holes on the Replacement Wooden Toilet Seat and Lid for Dometic Full-Timer RV and Sealand Toilets #DOM25FR is 5-1/2" center to center.

view full answer...

Answer 2

There's a good chance you have a Dometic RV toilet which I attached a picture that has all of the styles shown with the numbers that they correlate with. Check out what you have and compare to the picture and I'll see which…

view full answer...

Answer 3

Yes the Replacement Wooden Toilet Seat and Lid for Dometic Full-Timer RV and Sealand Toilets #DOM25FR that you referenced does fit your 500 Plus Series Dometic toilet.

view full answer...

Answer 4

The Dometic Toilet Seat part #DOM25FR is 19 inch by 15 inch by 3 inch. This fits the Dometic Traveler or Sealand Series 500 toilets.

view full answer...

Answer 5

In order to find out if the Replacement Wooden Toilet Seat and Lid for Dometic Full-Timer RV and Sealand Toilets - Tan #DOM25FR will fit your Thetford RV toilet you will need to take some measurements. There are quite a few different designs for…

view full answer...

Answer 6

To determine the correct replacement seat for your Dometic toilet we need to know the model number on your toilet. This information is found on the back of the toilet on the manufacturers label. Depending on the model it may be hidden behind a cover.…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Replacement Toilet Seat For Dometic 510 Full-Timer And Sealand Toilets

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching