What is the Distance from the Hitch Pin Hole of the Hitch Cover # OHCC003?
Question:
I am wondering what he distance is between the back side of the hitch plate and the hitch pin? I bought one hitch cover and it wouldnt work on my sons truck. Didnt want to have the same problem with this one too. His truck is a 1997 F250 Thanks
asked by: Karen D
0
Expert Reply:
On the Chicago Blackhawks 2" Hitch Cover # OHCC003, the measurement from the center of the hitch pinhole to the end of the tubing is 1/2 an inch. From the face of the cover to the center of the hitch pinhole, that measures 3 inches. I went ahead and attached a diagram of these measurements for your convenience.
expert reply by:
Bob C
0
Chicago Blackhawks Hitch Cover # OHCC003 Dimensions
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Chicago Blackhawks 2" NHL Trailer Hitch Receiver Cover - Zinc
- Hitch Covers
- Sports
- NHL
- Metal Face
- Fits 2 Inch Hitch
- Chicago Blackhawks
- Standard
- Oval
- Great American
more information >
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Trailer Maintenance Schedule
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778