Is There a Replacement Converter Section for the Elixer ELX45

Question

Question:

Yes I have a model number ELX45 converter on my camper can I get just the fuse panel board it short

asked by: Timothy C

0

Expert Reply:

I do have an option for you but we don't offer just a replacement converter section for the Elixer ELX45, you'll have to replace the entire panel using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger part # PD4045KA. You may also need to resize the cutout for the old panel.

expert reply by: Conner L

0

Answer 1

You can replace your Elixir 45amp converter charger with either the Progressive Dynamics Inteli-Power RV Converter and Battery Charger - 12V - 45 Amps #PD9145A (flooded lead acid, AGM, and gel batteries) or the Progressive Dynamics Inteli-Power RV…

view full answer...

Answer 2

We have a great option in a replacement 45 amp power converter for your ELX-45. I suggest the Progressive Dynamics, #PD4045KA. This is a 2-in-1 AC/DC distribution panel and smart charger that works with lithium-ion, flooded lead acid, AGM, and gel…

view full answer...

Answer 3

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 4

I have a solution for you but there isn't just a replacement converter section for the Elixir ELX-45. You're going to need to replace the entire panel with the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger item…

view full answer...

Answer 5

The Duo Therm is made by Dometic. We do offer the Advent Air Replacement RV Air Conditioner for Dometic Setups part #ACDOM135 which is a direct plug-in replacement. It will use the existing distribution box, thermostat, etc. as it's just a…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Is There a Replacement Converter Section for the Elixer ELX45

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching