Best Towing Mirrors For A 2022 Ram 1500

Question

Question:

what would e the best towing mirrors for a 2022 ram 1500

asked by: David S

0

Expert Reply:

For your 2022 Ram 1500, I recommend the K-Source Snap & Zap Custom Towing Mirrors # KS80730. These mirrors, when installed, retain your truck's OEM look to your mirrors, but also provide 3-3/8" of additional visibility, needed for towing.

These mirrors will not impact the functionality of any mirror supported functions, such as, puddle lights, blind spot detection, etc.

expert reply by: Bryce D

0

Answer 1

Yes, the K-Source Snap & Zap Custom Towing Mirrors #KS80730 will fit your 2022 Ram 1500 Big Horn. The incorrect fit has to do only with the Tradesman and Rebel models with the optional 6 x 9 manual mirrors. Since you do not have either of these,…

view full answer...

Answer 2

Yes! The K-Source Snap & Zap Custom Towing Mirrors - Snap On #KS80730 has a clear lens to see the turn signal indicator as well as cutouts for the bottom sensor and under lights. I went ahead and attached a great review video that goes over all…

view full answer...

Answer 3

The K-Source Snap & Zap Custom Towing Mirrors #KS80730 that you referenced will not interfere or block the cameras on the factory mirrors for your 2020 Ram 1500. These are a confirmed fit for your truck as long as you don't have the OEM…

view full answer...

Answer 4

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 5

The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for a…

view full answer...

Answer 6

I checked your order notes and the leaf springs you bought last year were the part #e28SR which are for 5k axles. Since this is over the capacity of your axle failure would not have been caused by over loading the trailer assuming you stayed under…

view full answer...

Answer 7

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 8

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 9

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 10

My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…

view full answer...

Answer 11

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Answer 12

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…

view full answer...

Best Towing Mirrors For A 2022 Ram 1500

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching