Replacement Ventline Vent Cover for 2018 Coleman Travel Trailer
Question:
i have a 2018 Coleman lantern LT travel trailer. I need to replace the vent cover/top/lid due to cracking. I cannot find any type of manufacture information on the vent. It is a manual crank open with fan. Can you recommend something \?
asked by: Tommy E
Expert Reply:
The more common manual opening vents for campers from this timeframe are the Ventline. But unfortunately not all vents or vent covers are the same. They are almost identical in size but the hinges and lift locations can vary. The best way to identify the correct lid/vent cover for your 2018 Dutchmen Coleman Lantern LT Travel Trailer is to look at the hinge point of the base when the cover is removed/open.
I've attached a photo of the different hinge styles to assist and linked the page to all of the vent cover/lid options. For instance the Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent # BVD0449-A03 has a continuous hinge with lift in the center and is one of the most common replacement lid covers used.
Products Referenced in This Question
Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent - Smoke - Wedge Shape - Plastic
- RV Vents and Fans
- Replacement Lid
- Roof Vent
- 14W x 14L Inch
- Plastic
- Tinted
- Ventline
more information >
Product Page this Question was Asked From
MaxxAir Standard Roof Vent Cover - 20" x 19" x 9-1/2" - Translucent White
- RV Vents and Fans
- Vent Cover
- Roof Vent
- 18-1/2W x 19L Inch
- Plastic
- White
- MAXXAIR
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Measure a Trailer Axle
- Q&A: Do Other Wires Need to be Installed on 2023 Honda CR-V With Curt 4-Way C56370
- Q&A: Is 3/4" Wide Butyl Tape Wide Enough For The MaxxFan MA00-07000K?
- Article: Flat Towing Package for 2002-2004 Jeep Liberty
- Q&A: Replacement Motor for LCI Power Stabilizer Jack Model 1917771
- Article: Flat Towing Package for 2005-2007 Jeep Liberty
- Q&A: Replacement Surge Brake Actuator To Replace Tie Down Model 125 12,500LB Drop Actuator
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Q&A: Hub and Drum Assembly with 8 on 6-1/2 Bolt Pattern for Dexter 10,000 Pound Trailer Axle
- Article: How to Replace an RV Roof Vent Cover
- Q&A: Where is Dexter Bearing 31-73-3 Made & Is It Timken
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide